Chinese
English
Industrial News
- 13 2021-05
-
Advantages of IP protection class test tool
Advantages 1. Small size, light weight, easy to carry, LCD display. 2. The waveform can be stored for a long time, and the stored waveform can be amplified and other operations and analysis. 3. It is especially suitable for measuring single-shot and low-frequency signals, and there is no flickering ...
- 13 2021-05
-
The waterproof grade of electronic products JIS (IPX)
IK protection level collision test requirements: 1. Atmospheric conditions during the test Unless otherwise specified in the relevant product standards, the test should be carried out under the standard atmospheric pressure described in GI3/T 2421-1999. 2. Temperature range: 150C-350C; air pressure:...
- 13 2021-05
-
In the vertical drop impact test, it is a vertical ball drop
The application and operation method of GB4706.1-50mm round baffle plate test finger: in compliance with regulations: GB/T16482-2008 Figure 2, IEC61032 Figure 2, GB/T16842 and GB4208 IP2, IEC60529 IP1, IEC60065, main purpose: to detect and avoid the body The basic safety protection of the components...
- 13 2021-05
-
Standard test pointer pin briefly describes what is a spring fatigue testing mac...
In the early loading methods of standard test pointer pin manufacturers, ordinary AC motors were mainly used to drive the transmission system, and the loading speed was not adjustable. For springs and other elastic parts, due to the tensile stress, data is automatically recorded during rapid compres...
- 13 2021-05
-
Do you know the temperature rise test angle of the generator?
When the generator is running, mechanical loss, copper loss, iron loss and other losses will occur. These losses are converted into heat. L4931CDT50-TR will increase the temperature of all parts of the generator, while the cooling medium will continue to take away heat. At the same time, when the he...
- 13 2021-05
-
Test tools are more convenient to test chips
The manufacturer of the IP protection test tool module writes the timing information in the SPD into the EEPROM and writes it into the EEPROM according to the characteristics of the memory chip used. The main purpose is to assist the Northbridge chip to accurately adjust the physical/timing paramete...
- 13 2021-05
-
What is the reason for the burning of the motor of the FCT test fixture?
The motor is damp. Decreased margins caused by water ingress or dampness are also common causes of damage. Daily protection must be done. Attention and regular testing. Especially for motors driven by inverters, you must be more careful about this, otherwise the inverter may be damaged. The internal...
- 13 2021-05
-
Analyze the purpose of the test standard of IP protection grade test tool
Except for Class II appliances, the IP protection test tool can cut off all the electrodes of the live parts of the visible glowing electric heating components and the supporting parts of these electric heating components with only one switch action, as long as they can be removed from the outside o...
Advisory
Mobile Site
QQ Advisory
0755-23702756
Follow us